Custom License Plate Bracket SHELBY GT350, GT350R, 2015-2020

The bracket that holds the license plate is laser cut from 16ga plate stainless steel (NOT PLASTIC) weighing in at only 7 oz. with the license plate attached. It has rubber bumper protection in place, to prevent vibration and so no metal part of the bracket never touches the painted portion of the car.

The mounting base is 6061 Billet Aluminum machined mounting base. It comes with a custom knurled thumb nut used to fasten the license plate bracket to the mounting base. The mounting base is attached to the bumper cover, out of sight, using 3M 4910 VHB (Very High Bond) adhesive tape, some of 3M’s strongest bonding tape on the market. This VHB tape will bond despite extreme ground-to-air temperature swings of 194°F to -30°F (90°C to -35°C) and support up to 90 lbs/in2. This bracket has 3 square inches of tape that adheres.

The all new attachment design was tested at various stages. It was initially tested by mounting the base to a painted surface with the bracket attached and we let it sit for a week; it didn’t move. Then we hung 10lbs of weight off the mounting base with the bracket attached and let it sit for a week; it didn’t move. Then we hung 41lbs of concrete off the mounting base; it didn’t move. Then we mounted it on a 2015-17 Mustang GT, took it up to 100mph (for a short period of time) using the 3M tape mounting option; it didn’t move. The mount is tested and proven and under no circumstances requires any additional screws to hold it in place. We did not test this mount with any heavy metal style license plate frames, only plastic frames and covers.

* Made in the USA from non-corrosive metal (aluminum and stainless steel)

* Light weight

* Quickly and easily removable for car shows and cleaning

* Places the license plate on the center of the bumper where it was intended to be mounted.

Note: This bracket will not work on cars with an aftermarket billet style grill installed in the lower air dam.

NOT MEANT FOR USE WITH HEAVY METAL STYLE LICENSE PLATE FRAMES.

REMOVE BRACKET PRIOR TO USING ANY TYPE OF AUTOMATIC (Brush or Touch-less) STYLE CAR WASH.