Carroll Shelby Racing LLC
  • ABOUT
  • STORE
  • Events
  • DRIVERS/PHOTOS
  • SPONSORS & CHARITIES
  • NEWS ROOM
  • CONTACT
  • CARS FOR SALE
  • CAR CARE PRODUCTS

Custom License Plate Bracket Mustang 2015-2020

SKU:
$59.95
$59.95
Unavailable
per item

The bracket that holds the license plate is laser cut from 16ga plate stainless steel (NOT PLASTIC) weighing in at only 7 oz. with the license plate attached. It has rubber bumper protection in place, to prevent vibration and so no metal part of the bracket never touches the painted portion of the car.

The mounting base is 6061 Billet Aluminum machined mounting base. It comes with a custom knurled thumb nut used to fasten the license plate bracket to the mounting base. The mounting base is attached to the bumper cover, out of sight, using 3M 4910 VHB (Very High Bond) adhesive tape, some of 3M’s strongest bonding tape on the market. This VHB tape will bond despite extreme ground-to-air temperature swings of 194°F to -30°F (90°C to -35°C) and support up to 90 lbs/in2. This bracket has 3 square inches of tape that adheres.

The all new attachment design was tested at various stages. It was initially tested by mounting the base to a painted surface with the bracket attached and we let it sit for a week; it didn’t move. Then we hung 10lbs of weight off the mounting base with the bracket attached and let it sit for a week; it didn’t move. Then we hung 41lbs of concrete off the mounting base; it didn’t move. Then we mounted it on a 2015-17 Mustang GT, took it up to 100mph (for a short period of time) using the 3M tape mounting option; it didn’t move. The mount is tested and proven and under no circumstances requires any additional screws to hold it in place. We did not test this mount with any heavy metal style license plate frames, only plastic frames and covers.


* Made in the USA from non-corrosive metal (aluminum and stainless steel)

* Light weight

* Quickly and easily removable for car shows and cleaning

* Places the license plate on the center of the bumper where it was intended to be mounted.

Note: This bracket will not work on cars with an aftermarket billet style grill installed in the lower air damn.

NOT MEANT FOR USE WITH HEAVY METAL STYLE LICENSE PLATE FRAMES.

REMOVE BRACKET PRIOR TO USING ANY TYPE OF AUTOMATIC (Brush or Touch-less) STYLE CAR WASH.

  • Facebook
  • Twitter
  • Pinterest
  • Google+
Add to Cart

Warnings

California Prop 65

California Air Resource Board              

Support

Terms & Conditions Of Use
Privacy Policy
Shipping Policy
Returns Policy
Shifter Knob Instructions
Shifter Knob Find Yours
Picture
 SHELBY®, CARROLL SHELBY®, CARROLL SHELBY LICENSING INC.®, CS LOGO®, CARROLL SHELBY RACING LLC.®, CARROLL SHELBY RACING LOGO(S)® ARE REGISTERED TRADEMARKS AND/OR TRADE DRESS USED UNDER OFFICIAL LICENSE. ALL RIGHTS RESERVED. UNAUTHORIZED USE STRICTLY PROHIBITED.
        © COPYRIGHT 2019
CARROLL SHELBY RACING LLC. ®
ALL RIGHTS RESERVED.

  • ABOUT
  • STORE
  • Events
  • DRIVERS/PHOTOS
  • SPONSORS & CHARITIES
  • NEWS ROOM
  • CONTACT
  • CARS FOR SALE
  • CAR CARE PRODUCTS